Zenith D27D53T Operating Manual & Warranty page 9

Hook Up Cable Service (CATV)
Connect cable service to your Entertainment Machine
1
Locate the Antenna/Cable jack on the
back of the TV.
Connect the cable service wire that runs
2
from the wall or cable box directly to this
jack, according to one of the diagrams to
the right.
3
Remove the back of the remote and put in
two "AA" batteries.
Back of
Remote
4
Plug in the TV. Do not plug it into an out-
let controlled by a switch. Your TV is
designed to operate on standard house-
hold current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC power.
If you're using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you're using a cable box, EZ Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don't worry, that's all
you need!
206-3594
Typical
Cable TV
Wall Jack
Coaxial Round Wire
(75 ohm)
Typical
Cable TV
Wall Jack
Cable Box
In
output
Out
switch 3 4
RF Coaxial Wire
(75 ohm)
Typical
TV Back
Typical
TV Back
P A G E 9