Table of Contents
Advertisement
Run Test Mode:
To enter Run Test Mode, scroll to
times, then begin the test.
To exit the test mode, momentarily push the Menu key, cycle power to the furnace, or make a valid thermostat
call for capacity or fan.
Sequence of Run Test Mode
1
-Turns the inducer on in 1 stage for 30 seconds
– Not applicable
– Turns the igniter on for 10 seconds
– Turns the circulating blower on 1
– Turns the circulating blower on 2
– Turns the circulating blower on 1 stage gas heat speed for 10 seconds
– Not applicable
The above sequence will repeat two more times unless the Run Test Mode is exited, see above.
Important:
the technician to observe each mode to ensure the IFC, inducer, and circulating blower are performing as intended.
A801X-SVX001-1C-EN
Run Test Mode
using the Menu key, then push the option key. The LED will flash
st
stage airflow for 10 seconds
nd
stage airflow for 10 seconds
The Run Test Mode does not test fire the furnace or bring the outdoor unit on. It is designed to allow
System Status Menu
Example
Example
1
st
Stage Pressure
Tap #2
Switch Error
1 dL=
HT
CP1 =
CP2 =
COF =
DFT =
TP1-9
(1) The menu status displayed is solely dependent on the input of 24VAC
that is applied to the low voltage terminal strip.
request every 2 seconds.
and airflow request. See first example.
A801X
A801X
Idle, no demand for cooling, heaing, or fan.
= Demand for stage gas heat.
Demand for cooling/heatpump.
Demand for 2nd stage cooling.
Demand for continuous
Demand for outdoor unit defrost, furnace running in gas heat mode.
=
Tap selected for
airflow.
he status will alternate between the system mode and the airflow
f an error occurs, an E*.* will alternately flash with the system mode
I I n n t t e e g g r r a a t t e e d d F F u u r r n n a a c c e e C C o o n n t t r r o o l l M M e e n n u u
fan.
45
Advertisement
Table of Contents
