Table of Contents
Advertisement
CONTROL FUNCTIONS
0®©0000 0
@)
(i)
BOOST
SUBSONIC
LPF
PHASE
GAIN
~
PWMOT
0. 0. •
•
~
0.
L ~
0..
12tlll0Ht
SSH&
50Ha
l!iOtv
MIN
MAX
©
REMOTE
~
c:=) c:=) c:=)
c:=)
c:=) c:=) c:=)
~~
c:=) c:=) c:=) c:=) c:=)
c:=)
c:=) c:=)
INPUT
'®'
c:=)
c:=)
c:=)
c:=)
c:=)
c:=) c:=)
c:=)
c:=)
\&I
0
liil
!Bl
I
!
ii_
ii. I
©
c:::::l
©
'"-===-ii
c:=)
c:=)
c:=) c:=) c:=) c:=) c:=) c:=) c:=)
1. Gain Control - The gain control matches the input sensitivity of the amplifier to the source unit
being
used.
The operating range varies from 200mv to
10V.
Adjusting the
gain:
1. Turn the gain control on the amplifier all the way down (counter clockwise).
2.
Turn up the volume control on the source unit to approximately
¾
of
maximum.
3.
Adjust the gain control on the amplifier until audible distortion
occurs.
4.
Adjustthe gain control down until audible distortion
disappears.
5.
The amplifier is now calibrated to the output of the source unit.
2. Phase Switch
-
Used to match the bass from subwoofers and front
speakers.
Toggle the phase
switch from
0°
to 180°. Keep the loudest bass
response.
3.
Remote Control Port - Use this port to connect the optional MTX
EBC.
It allows you to control
the
output level siting at the front of the
car.
4. RCA Inputs - These RCA inputs are used with source units that have RCA or Line level outputs.
(Source units need a minimum level of 100mV output for proper operation of the
amplifier).
MTX
recommends only high quality twisted pair cables (such as StreetWires) to decrease the
possibility of radiated noise entering the system.
5.
Power On/ Protection LED
-
The LED illuminates red when the amp is switched
on.
When the
amp is in short circuit or thermal
protection,
the LED is blinking. You need to switch off and on the
amp to
restart.
6.
Bass Boost - This can boost bass level up to
12dB.
The boost frequency is centered
at
45Hz.
MTX.COM
5
Advertisement
Table of Contents
