PEAK COMMUNICATIONS RCU100 Installation And Operating Handbook page 17

Webpage
The webpage is essentially split into two screens, Status and Configure, each one accessible via the links part
way down the screen. The webpage is displayed by entering the unit's IP address into a normal web browser.
TCP
The units can be controlled via TCP, this involves sending the normal RS232/485 commands to the unit through
a TCP port. The TCP port to be used is set by the user via one of the remote control interfaces.
SNMP
The units can be controlled via SNMP, the MIBS necessary for this are available from the Peak
Communications website. Please refer to the Peak-Agents.MIB file, as this shows which of the MIBS available
is used for the unit in question.
Issue 3.15 RCU100 and RCU200 redundancy control units Page 17