Ethernet Control - PEAK COMMUNICATIONS RCU100 Installation And Operating Handbook

ETHERNET CONTROL

As mentioned previously, if the RCU100/200 Redundancy control system units have been fitted with the
Ethernet option the unit can be controlled via its in built web page, TCP or SNMP.
Due to a lack of front panel on these units, it is not possible to display the IP address and other Ethernet settings
to the user easily. In order to discover the IP address and other Ethernet settings, initially only, the Peak
discovery windows programme needs to be run.
This software is available off the Peak website, when run it lists the units on the network, and allows the user to
view and modify, if necessary, the Ethernet settings to suit the user's network
The Configure IP settings button will bring up the following screen:
This allows the changing of the Ethernet settings, the initial password is "password", after the initial settings
change, it will change to "PEAKpass123", and is case sensitive.
In order for the new settings to be used the unit must be restarted by cycling the power.
Issue 3.15 RCU100 and RCU200 redundancy control units Page 16