Table of Contents
Advertisement
Simply replace the filename of IBM's adapter handler in the batch file's
first line with L5250AH.COM. This change will cause STARTPCS.BAT to
load L5250AH instead of the IBM adapter handler.
Remember to save the edited STARTPCS.BAT file in ASCII form.
Reboot your PC or PS/2 after you modify STARTPCS.BAT.
1.4.2
Adapter Handler Installation
Copy the following files from your L5250AH master diskette into the PCS
directory that was created when you installed the IBM software:
•
Adapter Handler Program - L5250AH.COM
•
Microcode for 5250 Twinax Card -
L5250AH.MIC
•
Microcode for STWINAX Card- L5250AH.SMC
1.4.3
Adapter Handler Configuration
The L5250AH Adapter Handler is preconfigured with default settings that
probably will fit your needs. You may, however, need to reconfigure the
software to use settings other than the defaults. You can specify
configuration settings by starting the Adapter Handler using a command
line with certain options. Following is a description of these options.
The command line used to configure the Adapter Handler has the form:
L5250AH -Annnnn -lnnnnn -U
You may include one or more of these options in any order, separated by
one or more spaces.
A sample command line might be:
L5250AH -AC800 -1300 -U
1-5
Advertisement
Table of Contents
