Fingered Chord Zone Assignment - Yamaha QY-300 Owner's Manual

Fingered Chord Zone Assignment

ABC chord changes will
be ignored during step
or realtime recording of
any track other than the chord
track, and in the edit or job
modes.
Note Note data filter. This filter should normally be turned off to
allow reception of all note data.
Pitch Bend Turn this filter on if you do not want to record pitch bend data
received by the QY300, or you simply don't want received pitch
bend data to affect the QY300 sound.
Cntrl Change This filter can be used to block reception of all control
change events: modulation, breath controller, volume, sustain
pedal, etc. Control change bank select numbers (0 and 32)
are affected by the Program Change filter (below), not the
Cntrl Change filter.
Program Change The program change filter can be turned on if you want to switch
voices on an external keyboard or other controller without
switching the QY300 voices as the same time.
Poly After As mentioned aove, aftertouch generates a lot of data that can
rapidly fill the available memory if used indiscriminately. When
on, this filter blocks reception of polyphonic aftertouch data.
Ch. After Similar to the polyphonic aftertouch filter, but this filter blocks
reception of monophonic (channel) aftertouch data.
Sys Ex. Blocks reception of all system exclusive data when turned on.
The QY300's advanced ABC system can be controlled from an external key-
board, making it useful as an ABC expander module. The Fingered Chord
Zone utility function sets the range of notes in which chords played will be
recognized by the QY300 ABC system.
The Utility Mode
117