Table of Contents
Advertisement
•
•
•
AEC/Appllcatlon Engineering
5. Using a cardboard disc to protect the lapped face of the seal seat, press the seal seat
assembly to the bottom of the seal housing bore using a piece of wood. You can also use an
arbor press to install the seal seat. The seal seat must be started square and carefully pressed
to the bottom of the seal housing bore.
6. Place the tapered installation sleeve on
the shaft. Refer to the first figure on
this page.
Coat the inner diameter of the seal
rotary member, tapered installation
sleeve, and the shaft with a generous
quantity of non-detergent SAE 30-
weight oil. Place the rotary member on
the shaft over the sleeve and against
the hub of the rotor. Refer to the
second figure on this page.
Some Teflon™ seals are equipped with
holding clips that compress the seal springs.
Remove the holding clips to release the
springs after you install the seal on the shaft.
Tighten all drive setscrews securely to the
shaft.
At this point, complete the assembly procedures
starting at Step 9 on Page 50 in the previous
section, Standard Mechanical Seal, Synthetic
Rubber Bellows Type.
TAPERED INSTAUATION SLEEVE
ANTI-AOTATION PINS ALIQNEO
INSTALLATION TOOL
WITH SLOTS IN BUSHING
COAT WITH LIGHT OIL
BEFORE ASSEMBl Y
BRACKET SEAi. HOUSING 80RE
WITH
SEAi. SEAT
rNSTAUED. NOTE SPECIAL INSTALLATION TOOL USED
FOR FACTOAYASSEMBLV .
TOH True Temp™ Serles Hot Oii Temperature Control Units
Page 53
Advertisement
Table of Contents
