Editing The Dr/Pc Native Part Parameters - Yamaha PLG150-DR Owner's Manual

For XG Plug-in System Users

Editing the DR/PC Native Part Parameters

Any of the DR/PC voices can be freely edited from the front panel with the DR/PC Native Part param-
eters. Keep in mind that changing the Part parameters does not permanently affect the original voice
settings. The edits that you make here temporarily change the settings of the currently selected voice.
When you select a different voice for the Part, the settings are applied to the newly selected voice.
• The parameter values and settings below represent offsets of the actual voice settings. This means that
NOTE
• The Part parameter settings cannot be saved in Multi Play mode. If you wish to save your Part parameter
• The example displays used in the following explanations are all taken from the MU128.
1
Select the Part having the DR/PC voice, then select the desired voice.
Select the appropriate Part with the [PART –/+] buttons, then, with the cursor at the Voice Num-
ber parameter, select the desired voice.
2
Press the [EDIT] button to enter the Edit mode.
3
Select the "PLUGIN" menu.
Use the [SELECT >] button, then press the [ENTER] button. The PLG150-DR/PLG150-PC
Edit menu appears.
4
Select the desired parameter.
Use the [SELECT </>] buttons.
5
Adjust the value or change the setting for the selected parameter.
Use the [VALUE +/–] buttons.
6
Return to the main Play display.
Press the [EXIT] button several times, or press the [PLAY] button once.
12
adjustments made to the parameters may not make much change in the actual sound, depending on the orig-
inal settings of the voice. For parameter values, a setting of "0" results in no change, while positive and nega-
tive values increase and decrease the value respectively.
edits, do it from the Performance mode or Plug-in Board Editor.