Editing The Pf Native Part Parameters (Modular Synthesis Plug-In System) - Yamaha PLG150-PF Owner's Manual

Editing the PF Native Part Parameters
(Modular Synthesis Plug-in System)
Keep in mind that the parameter values and settings below represent offsets of the actual voice settings. This
means that adjustments made to the parameters may not make much change in the actual sound, depending
on the original settings of the voice. For parameter values, a setting of "0" results in no change, while positive
and negative values increase and decrease the value respectively.
The following explanations show how to edit the PF native part parameters when creating PLG voices, using
the CS6x Control Synthesizer as an example. For information on storing the PLG voices with your particular
Modular Synthesis Plug-in System compatible instrument, refer to the owner's manual of that instrument.
1
Select the desired PF voice, as described in "Selecting PF Voices" on page
12.
2
Press the EDIT button.
The EDIT menu display appears.
3
Turn knob A clockwise until "Elem" is shown at the bottom left of the dis-
play.
4
Turn the PAGE knob clockwise until "PLG150-PF" is shown at the bottom
left of the display.
Keep turning the knob to select the different PF Part parameters, indicated just above knob C and
knob 2.
5
Use knobs C and 2 to select the desired parameter and change the value.
Once one of the parameters is selected (the arrow cursor appears next to the value), you can also
adjust the value with the DATA knob or the DEC/INC buttons.
GEN Name) Pf-Sq
Commom
PLG Assign)
Elem 080/000
NTV Param) PF Mode
PLG150-PF
a-Z 0-? Cursor
[PF:GndPnoSt
Bank Number
1[GndPnoSt]
SusCurve
ON Normal
]
13