Accessories; Disposal - Weller WX 200 Operating Instructions Manual

WXP 200
Note
Replacing a used tip
1. Place the soldering tool in the WDH 31 safety rest.
2. Switch off the power switch of the supply unit.
3. Wait five minutes until the soldering tip has cooled down.
4. Hold the soldering iron with the tip facing slightly downwards.
Hold the soldering iron by the rear handle (5) and unscrew the tip
receptacle (3) using the supplied 17 mm open end wrench
Pull off the soldering tip (2) forwards
The soldering tip is now resting loosely in the tip receptacle (3)
Do not place or leave the hot soldering tip or probe tip on the
cleaning sponge or on plastic surfaces. When using multiple types
of soldering tip, it is recommended that the soldering tip (2) and tip
receptacle (3) be used together in the changing system (see figure
above).
Keep the heat transfer surfaces of the soldering tip and heating
element clean. The heating element must not come into contact with
soldering tin.
Inserting a new soldering tip
5. Place the soldering tip into the tip receptacle with the tip facing
forwards. Push the tip receptacle together with the soldering tip
over the heating element and screw the soldering tip securely
into place using a 17 mm open end wrench.
Tighten to a low torque, as otherwise you might damage the
tapered part of the heating element.
6. Switch on the power switch of the supply unit and set the
temperature to the required level.

7 Accessories

7.1 XHT soldering tips for the WXP 200 soldering
iron
See the table XHT soldering tips for WXP 200 soldering iron in the
section in the back and at www.weller.eu
7.2 Replacement parts and accessories for
WXP 200
Order no. Description
T0052920599 WXP 200 soldering iron
T0051515898 WDH 31 safety rest
T0051384199 Metal wool for cleaning element for WDC 2
T0058741753 17 mm open end wrench

8 Disposal

Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.
7-8