Fault Messages And Fault Elimination; Accessories; Disposal; Warranty - Weller WSD 151 Instructions Manual

10-10
Message/Symptom
Display: "- - -"
Display: "tip"
No display function
(display off)

8 Fault messages and fault elimination

Possible cause
Tool has not been detected
Tool defective
Soldering tip of microtool not
correctly inserted or defective
No mains supply voltage

9 Accessories

T005 87 447 38 Heating element HER, 80 W
T005 87 637 30 Heating element HER, 120 W
T005 29 170 99 WSP 150 Soldering-bit set, 150 W
T005 26 152 89 LR 82 R (robot application)
T005 27 040 99 WSB 80 Soldering bath, 80 W
T005 27 042 99 WSB 150 Soldering bath, 150 W
T005 29 180 99 WP 80 Soldering iron, 80 W
T005 29 161 99 WSP 80 Soldering-bit set, 80 W
T005 33 131 99 MPR 80 Soldering-bit set
T005 33 155 99 WMP Soldering-bit set, 65 W
T005 29 187 99 LR 21 Soldering-bit set, 50 W
T005 33 133 99 WTA 50 Unsoldering-tweezer set, 50 W
T005 27 028 99 WHP 80 Preheater plate
T005 31 180 99 WCB 2 External input unit
T005 25 032 99 WST 82KIT1 Thermal stripping set
T005 25 031 99 WST 82KIT2 Thermal stripping set
T005 15 161 99 WDH 10T Switching holder WP 80/WSP 80
T005 15 162 99 WDH 20T Switching holder for WMP

10 Disposal

Dispose of replaced equipment parts, filters and old devices in
accordance with the rules and regulations applicable in your country.

11 Warranty

Claims based on defects will fall under the statute of limitations 12
months after delivery to the purchaser of the goods. This shall not
apply to rights of recourse of the purchaser according to sections
478, 479 German Civil Code.
We shall assume liability for warranties supplied by us only if the
quality guarantee or service warranty has been submitted in writing
and using the term "Warranty".
Subject to technical alterations and amendments! See the updated
operating instructions at www.weller-tools.com
WSD 151 / PUD 151R
Corrective measures
Check connection of tool to device
Check connected tool
Insert soldering tip again
Replacing defective soldering tip
Turn on mains power switch
Check mains supply voltage
Check device fuse