Protocol CUT80 Product Manual page 13

ATTACHING SLIM PROFILE TOOL MOUNTS TO YOUR MITER SAW
3. FOR OVERHANG MOUNTING: Tool mounts are pre-installed for overhang mounting.
Stair steps should already be installed in first and third holes starting from tool mount
handle side.
4. FOR CENTER MOUNTING: Use 4 mm hex key to loosen screws and remove stair steps
from tool mount. Reinstall stair steps into second and fourth holes. Make sure stair steps
are facing away from tool mount handle. Repeat this step for the other tool mount.
O-RING
CARRIAGE BOLT
5. Feed two carriage bolts from underneath the tool mount, one bolt per slot.
6. Add a rubber O-ring to each carriage bolt.
FIND OUT MORE AT PROTOCOLEQUIPMENT.COM
1ST HOLE
2ND HOLE
3RD HOLE
4TH HOLE
13