Yamaha MT2X Authorized Product Manual page 22

6. Adjusting level balance and equalization
characteristics
Adjust channel faders 1 and 2 to achieve the desired
recording level balance.
Adjust the equalizers for 1 and 2 to obtain the
desired sound character for each individual chan-
nel. (If you're thinking of ping-ponging these tracks
afterwards, it's a good idea to add a little boost on
the HIGH EQ because high frequencies can be
slightly diminished during the ping-pong re-record-
ing process).
Set the effect level for each channel with the AUX
controls. Then, adjust the overall mix of effect
signal to input signal with the AUX MASTER SEND
control.
If necessary, go over steps
until everything is just right.
Adjust the master recording level with the MASTER
fader, setting it at the point where the "+3" in-
dicator on the far left level meter flashes occa-
sionally on the sound peaks.
to several times
7. Recording
Push the PAUSE switch to start recording. Just
before the rhythm programmer is started, be sure
to "count" out loud to help you get the timing right
on the other tracks during overdubbing later on.
When the music sequence is over, press the STOP
switch to stop the recording. Then, press the REW
switch, and the tape will rewind to a point just
before the beginning
and stop.
— Drum Recording Completed —
Track 1
Track 2
Track 3
Track 4
"999" on the tape counter
2 0