Yamaha MT2X Authorized Product Manual page 13

PHONES SELECT SWITCH
You can plug a set of headphones into the PHONES jack
SELECT Switch is used to select the signal to be monitored. Control the volume level with the PHONES volume
control .
STEREO Position:
Put the switch in this position to monitor the signal output through the ST OUT jacks
nels of the stereo signal will be heard through the headphones.
When set to this position during ping-ponging or mixdown operations, the mixed signal of all the instruments can
be monitored.
MONITOR Position:
This position is for monitoring the signal of each track. You can freely monitor while mixing the sound of each
track during recording or playback. Using the MONITOR LEVEL Controls
MIX Position:
This position allows you to simultaneously monitor
both the sound heard in the STEREO position and the
sound heard in the MONITOR position. Setting to this
position during punch-in/punch-out operations will
enable the type of monitoring shown below. (Refer to
"Punch-in/Punch-out" on page 27).
11
on the front panel to monitor the sound. The PHONES
set the desired level for each track.
For example, when adding in instruments or vocals in the following
way:
The sound of
tracks 1-4
plus the sound
of the material
to be added.
. The Left and Right chan-
For retake
Tracks 1-3
plus the
sound of the
material
added.