Yamaha MT2X Authorized Product Manual page 21

4. Setting the monitor and meter sections
Set the PHONES SELECT switch to the "STEREO"
position.
S e t t h e P H O N E S v o l u m e t o a r o u n d " 7 " .
Make sure the METER SELECT switch is in the "4
TRK" position.
5. Adjusting the input level
Set the channels 1 and 2 input switches to the
MIC/LINE position.
Set the MASTER fader to "7".
Set the PAN controls for channels 1 and 2 between
the center and the extreme "L" position, as shown.
19
Push the input faders for channels 1 and 2 up to
"7".
Set the GAIN controls to the LINE position, start the
rhythm programmer and adjust its output level so
the "+3" segment on the track-1 level meter lights
only briefly on the signal peaks.
Pull the input faders back down to "0".
— The proper input levels for channels 1 and 2 are
now set. —