ROOMS TO GO OPTIONS 5021-52phr Assembly Instructions

USB
Assembly instructions for OPTIONS 5021-73phr
Headrest/Clos
Seat/Open
Headrest/Open
Base lights,cup holder
Seat/Clos
ON/ OFF
Raffel Cup
Holder
Note: Make sure all PLUGS are connected
on the product before plugging power
cord into power outlet. If not damage can
occur.
The USB ports (where applicable) are
designed with working voltage of 5V, and
can NOT be used to supply power for
Slide the metal post
1.
laptop computers (neither PC or Mac).
over metal
Plugging a laptop computer to the USB
receiver,press both sides
port may end up damaging either the
until locked in place.
computer or the USB port due to
A
B
Slide the metal
3.
post over metal
receiver,press
both sides until
locked in place.
2.Unzip the dust
4.Connect the
cover in the bottom
headrest wire A with
of console,remove
wire B in the rear of
the console back.
the seat.(Same as it in
left side)
USB
Seat/Open
Headrest/Open
Seat/Clos Base lights,cup holder
ON/ OFF
Raffel Cup
Holder
Note: Make sure all PLUGS are connected
on the product before plugging power
cord into power outlet. If not damage can
occur.
The USB ports (where applicable) are
designed with working voltage of 5V, and
can NOT be used to supply power for
laptop computers (neither PC or Mac).
Plugging a laptop computer to the USB
port may end up damaging either the
computer or the USB port due to
USB
Seat/Open
Headrest/Open
Seat/Clos Base lights,cup holder
ON/ OFF
Raffel Cup
Holder
Note: Make sure all PLUGS are connected
on the product before plugging power cord
into power outlet. If not damage can occur.
The USB ports (where applicable) are
designed with working voltage of 5V, and
can NOT be used to supply power for
5 .Plug the wall power laptop computers (neither PC or Mac).
Plugging a laptop computer to the USB port
cord into DC port in
may end up damaging either the computer
the rear of the
seat,then plug or the USB port due to unmatched working
another side into voltage.
power outlet to
Assembly instructions for OPTIONS 5021-52phr
Headrest/Clos
E
G
F
H
3.Connect the
wireless charger E
with F in the rear of
2.Connect the reading
lights wire G with H
in the rear of the
seat.
Slide the metal post over
1.
metal receiver,press both sides
until locked in place.
Assembly instructions for OPTIONS 5021-85phr
Headrest/Clos
A
B
.Connect the
2
headrest wire A with
.Slide the metal post over
wire B in the rear of
1
metal receiver,press both
the seat.
sides until locked in place.
Adjustable screws
Lift up cover over
the adjustable
screws.Use screw
A
driver and turn
clockwise to tighten
if needed.
B
5、Plug the wall power
cord into DC port in
the rear of the
seat,then plug another
side into power outlet
to operate.
Connect the
4.
headrest wire A with
wire B in the rear of
the seat.(Same as it in
Raffel Cup
Holder
Plug the wall power cord into
3.
DC port in the rear of the
seat,then plug another side into
power outlet to operate.