Operation - Yamato CDQ 12 LV Manual

mod. CDQ 12 LV (cod. 83510)
Installing or removing the quick-change keyless chuck
To install the quick-change keyless chuck, pull the
sleeve of the keyless chuck in the direction of the
arrow and insert the keyless chuck onto the shaft
as far as it will go.
Then release the sleeve to secure the keyless
chuck until it locks in place with a little click.
To remove the keyless chuck , perform the
installation procedure in reverse.
Installing or removing drill bit
Turn the Quick-change keyless chuck
counterclockwise to open the chuck jaws. Place the
driver bit/drill bit in the chuck as far as it will go.
Turn the chuck clockwise to tighten the
chuck. To remove the driver bit/drill bit, turn the
chuck counterclockwise.

OPERATION

CAUTION: Always insert the battery cartridge all the way
until it locks in place. If not, it may accidentally fall out of the
tool, causing injury to you or someone around you.
CAUTION: When the speed comes down extremely,
reduce the load or stop the tool to avoid the tool damage.
Hold the tool firmly with one hand on the grip and the other
hand on the bottom of the battery cartridge to control the twisting
action.
NOTICE: Do not cover vents, or it may cause overheating and
damage to the tool.
► 1. Quick-change keyless chuck 2. Sleeve 3. Shaft
► 1. Quick-change keyless chuck 2. Close 3. Open 4. Drill bit
► 1. Vents