Functional Description - Yamato CDQ 12 LV Manual

mod. CDQ 12 LV (cod. 83510)
7. Do not leave the tool running. Operate the tool only when hand-held.
8. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely
hot and could burn your skin.
9. Some material contains chemicals which may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material supplier safety data.
10. If the drill bit cannot be loosened even you open the jaws, use pliers to pull it out. In such a
case, pulling out the drill bit by hand may result in injury by its sharp edge.
SAVE THESE INSTRUCTIONS.
WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace
strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules
stated in this instruction manual may cause serious personal injury.
Important safety instructions for battery cartridge
1. Before using battery cartridge, read all instructions and cautionary marking son
(1)batterycharger, (2) battery, and (3) product using battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter, stop operating immediately. It may result in
a risk of overheating, possible burns and even an explosion.
4. If electrolyte gets into your eyes, rinse them out with clear water and seek medicalattention
right away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
- Do not touch the terminals with any conductive material.
- Avoid storing battery cartridge in a container with other metal objects such as nails, coins,
etc.
- Do not expose battery cartridge to water or rain.
A battery short can cause a large current
flow, overheating, possible burns and even a breakdown.
6. Do not store the tool and battery cartridge in locations where the temperature may reach or
exceed 50 °C.
7. Do not incinerate the battery cartridge even if it is severely damaged or is completely worn
out. The battery cartridge can explode in afire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to the Dangerous Goods Legislation
requirements. For commercial transports e.g. by third parties, forwarding agents, special
requirement on pack- aging and labeling must be observed. For preparation of the item being
shipped, consulting an expert for hazardous material is required. Please also observe possibly more
detailed national regulations. Tape or mask off open contacts and pack up the battery in such a
manner that it cannot move around in the packaging.
11. Follow your local regulations relating to disposal of battery.
12. Use the batteries only with the products specified by YAMATO. Installing the batteries to non-
compliant products may result in a fire, excessive heat, explosion, or leak of electrolyte.
SAVE THESE INSTRUCTIONS.
CAUTION: Only use genuine YAMATO batteries. Use of non-genuine YAMATO batteries, or batteries
that have been altered, may result in the battery bursting causing fires, personal injury and damage. It will
also void the YAMATO warranty for the YAMATO tool and charger.
Tips for maintaining maximum battery life
1. Charge the battery cartridge before completely discharged. Always stop tool operation and
charge the battery cartridge when you notice less tool power.
2. Never recharge a fully charged battery car- tridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room tempera- ture at 5°C - 45 °C. Let a hot battery
cartridge cool down before charging it.
4. Charge the battery cartridge if you do not use it for a long period (more than sixmonths).

FUNCTIONAL DESCRIPTION