Yamaha MT-09 SP Owner's Manual page 47

Turn signal switch " /
This switch controls the turn signal
lights. This is a 2-stage switch, mean-
ing that pressing it soft or hard has a
different effect.
Soft press: Lightly press the switch in
the direction you wish to signal, until a
soft click is felt. The corresponding
turn signal light will flash three times
and stop.
Hard press: Firmly press the switch in
the direction you wish to signal, until a
stronger click is felt. The correspond-
ing turn signal light will flash continu-
ously until all of the
conditions occur:
 The vehicle travels approx. 150 m
(490 ft).
 More than 15 seconds has el-
lapsed.
 The vehicle speed is more than 5
km/h (3 mi/h).
NOTICE
Depending on the conditions, the
turn signal may not automatically
turned off within the specified time
or distance travelled.
To cancel a turn signal manually, press
EAUA1741
"
the switch a second time in the same
direction.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards "
page 8-2 for starting instructions prior
to starting the engine.
Set this switch to "
following
gine in case of an emergency, such as
when the vehicle overturns.
Hazard switch " "
With the vehicle power is on, use this
switch to turn on the hazard lights (si-
multaneous flashing of all turn signal
ECA28520 lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard. Hazard lights
can be turned on/off only when the ve-
Instrument and control functions
hicle power is on. Even after the vehicle
power is turned off, they will continue
to flash until the vehicle is powered on
again and the hazard lights are
EAU66030 switched off.
"
NOTICE
Do not use the hazard lights for an
EAU94790
/ / "
extended length of time with the en-
gine not running, otherwise the bat-
", and then push tery may discharge.
". See
Cruise control switches
See page 4-5 for an explanation of the
" to stop the en-
cruise control system.
YRC mode button "MODE"
EAU95652
Short press this button to cycle the
YRC mode presets.
Theme1-3: Long press this button to
open a YRC mode pop-up at the bot-
tom of the display.
See page 6-9 and 6-26 for more infor-
mation.
6-2
ECA10062
6
EAUA1930
EAUA1941