Lincoln Electric PIPELINER 200 Service Manual page 132

F-62
REMOVAL AND REPLACEMENT PROCEDURE
FIGURE F.28 – MAIN GENERATOR ARMATURE MOUNTING
PROCEDURE
1. Turn the engine OFF.
2. Perform the DC Exciter Armature Removal
procedure.
Main
3. Perform the
Removal procedure.
4. Using the rope sling, support the armature.
5. Make sure the engine supported with the
wood or steel blocks.
6. Using the 5/8" wrench, remove the eight bolts
and lock washers holding the blower paddles
and the armature to the engine flywheel. See
Figure F.28.
7. With the armature supported and "balanced"
in the rope sling, carefully rotate the armature
1/8 turn in either direction to release it.
CAUTION
The armature is now free to be removed from
the engine.
TROUBLESHOOTING & REPAIR
MAIN GENERATOR ARMATURE
Generator Frame
PIPELINER® 200
SLING
MOUNTING BOLTS /
LOCK WASHERS (8)
Replacement: Refer to Figure F.28
1. Support the armature with the rope sling.
Mount the armature to the engine, rotating it
1/8 turn in either direction to achieve attach-
ment. Before removing the rope sling, be
careful to support the armature with the wood
or steel blocks under the engine. With the
5/8" wrench, install the eight bolts and lock
washers that attach the blower paddles and
the armature to the engine flywheel.
2. Perform other replacement
according to each of the following:
Generator Frame
Replacement
DC Exciter Armature
Replacement
F-62
BLOWER PADDLE
procedures
Removal and
Removal and