Adjustments Before Operation - Yamaha DDP-1 Owner's Manual

ADJUSTMENTS BEFORE OPERATION

SELECTING THE INPUT AND OUTPUT MODES SUITABLE FOR YOUR
SPEAKER SYSTEM
This unit provides you the following five functions to determine the modes of input and distribution of output signals to speakers
suitable for your audio system. C4 and C5 have been already preset in the position suitable for using this unit with the RX-V2090.
Description of each function
C1. INPUT
Choices: RF/OPT./COAX.
Preset position: RF
Selects the name of the input terminal on the rear of this unit
used for the connection with an AC-3 laserdisc player or
another AC-3 unit.
C2. CENTER SPEAKER
Choices: SML/LRG/PHANTOM
Preset position: SML
SML: Select this position when you use a center speaker
that is smaller than the main speakers. In this
position, low bass signals (below 90 Hz) at the
center channel are output from the MAIN OUTPUT
terminals.
LRG: Select this position when your center speaker is
approximately the same size as the main speakers.
PHANTOM:
Select this position when you do not have a center
speaker. The center channel sound will be output
from the left and right main speakers.
C3. REAR SPEAKERS
Choices: SMALL/LARGE
Preset position: SMALL
SMALL: Select this position if your rear surround speakers do
not have a high ability for bass reproduction.
In this position, low bass signals (below 90 Hz) at the
surround channels are output from the MAIN
OUTPUT terminals.
LARGE: Select this position if your rear surround speakers
have a high ability for bass reproduction, or a
subwoofer is connected to the surround speaker in
parallel.
In this position, full range signals are output from the
SURROUND OUTPUT terminals.
10
C1. INPUT
C2. CENTER SPEAKER
C3. REAR SPEAKERS
C4. MAIN SPEAKERS
C5. LFE/BASS OUT
C4. MAIN SPEAKERS
Choices: SMALL/LARGE
Preset position: LARGE
SMALL: Select this position if your main speakers do not
have a high ability for bass reproduction. However, if
your system does not include a subwoofer, do not
select this position.
In this position, low bass signals (below 90 Hz) at the
main channels are output from the SUBWOOFER
OUTPUT terminals (if the SUBWOOFER position is
selected on "C5. LFE/BASS OUT").
LARGE: Be sure to select this position, if this unit is
connected to an amplifier or receiver (RX-V2090
etc.) equipped with 5-ch discrete AC-3 input
terminals.
In this position, full range signals present at the main
channels are output from the MAIN OUTPUT
terminals.
Select this position if your main speakers have a
high ability for bass reproduction.
C5. LFE/BASS OUT
Choices: MAIN/SUBWOOFER
Preset position: MAIN
MAIN: Be sure to select this position, if this unit is
connected to an amplifier or receiver (RX-V2090
etc.) equipped with 5-ch discrete AC-3 input
terminals.
In this position, full range signals present at the main
channels, signals from the LFE channel and other
low bass signals that are selected on C2 to C4 to be
distributed from other channels are output from the
MAIN OUTPUT terminals.
SUBWOOFER:
Select this position if this unit is connected to an
amplifier or receiver equipped with a subwoofer (or
LFE) input terminal.
In this position, signals at LFE channel and other low
bass signals that are selected on C2 to C4 to be
distributed from other channels are output from the
SUBWOOFER OUTPUT terminals.