Playing An Ac-3 Source; Adjusting Output Levels - Yamaha DDP-1 Owner's Manual

1
Turn down the volume to minimum on the amplifier.
2
Turn the power on to the AC-3 unit, this unit, the
amplifier, the monitor etc.
The following output level adjustments are possible on this unit. Adjust them as you prefer, monitoring source sound.
Description of each function
B2. LEFT SURROUND LEVEL
Control range: –6 dB to +6 dB (in 1 dB step)
Preset value: 0 dB
Adjusts the output level at the left surround channel.
You had already adjusted the level in "OUTPUT BALANCE
ADJUSTMENT" on page 13, however you can change the
level if you wish.
B3. RIGHT SURROUND LEVEL
Control range: –6 dB to +6 dB (in 1 dB step)
Preset value: 0 dB
Adjusts the output level at the right surround channel.
You had already adjusted the level in "OUTPUT BALANCE
ADJUSTMENT" on page 13, however you can change the
level if you wish.
14

PLAYING AN AC-3 SOURCE

TEST MODE MENU PARAMETER

ADJUSTING OUTPUT LEVELS

B2. LEFT SURROUND LEVEL
B3. RIGHT SURROUND LEVEL
B4. LFE MIX LEVEL
B5. OUTPUT TRIM
3
If necessary, change the input mode setting on the
amplifier to the "5-ch discrete AC-3 input".
* For the RX-V2090, press the LD/TV button on the
front panel of the RX-V2090 so that "5 CH DISCRT"
appears on the display. (Refer to the section "Dolby
Surround AC-3" of the RX-V2090's manual.)
4
Play an AC-3 source on the AC-3 unit.
5
Turn up the volume on the amplifier.
6
If desired, adjust output levels, delays, dynamic range,
etc. on this unit. (See page 14–17 for details.)
B4. LFE MIX LEVEL
Control range: MUTE, –20 dB to 0 dB (in 1 dB step)
Preset value: 0 dB
Adjusts the output level at the LFE (low frequency effect)
channel. If the LFE signals are mixed with signals at the main
channels, only the level of the LFE signals are adjusted.
When adjusted to MUTE, only the LFE sound will not be
output.
B5. OUTPUT TRIM
Control range: –9 dB to 0 dB (in 0.5 dB step)
Preset value: 0 dB
Adjusts the output level at all channels.