Connect Fill Hose To Fill Valve; Drain Hose Connection - Whirlpool WDT975SAHV Installation Instructions Manual

15.
Slide nut and ferrule onto tubing
(copper tubing only)
Copper tubing only: Put the tubing into the 90° elbow fitting
as far as it will go. (The copper tubing bends and kinks easily.)
Slide the nut and ferrule forward and start the nut onto the
elbow threads.
NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base,
frame, or motor. Go to Step 17.
16.
Flexible line
Flexible braided line: Confirm the flexible braided line is long
enough. See the "Tools and Parts" section at the front of the
guide for part details and orders.
17.
Add 90° elbow fitting to the
water supply line
Get / " (9.5 mm) compression x
3
8
90° elbow. See the "Tools and Parts" section at the front of the
guide for part details and orders. Connect the
compression fitting of the 90° elbow fitting to the water supply
line. Attach such that the
upward as shown above.
29-Aug-2018 12:50:53 EDT | RELEASED
Nut
Ferrule
/ " (19 mm) hose fitting with
3
4
/ " (9.5 mm)
3
8
/ " (19 mm) connection is facing
3
4
In some European factories the letter "W" of the part code mentioned herein will be automatically

CONNECT FILL HOSE TO FILL VALVE

18.
Tighten 90° elbow fitting to valve
Be sure rubber washer is properly seated in fitting. Slide the
3 / " (19 mm) fitting of the 90° elbow up to the valve and hand
4
tighten to avoid cross-threading. Hand tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 1 / (6.35 mm) to
4
may be required to seal the rubber gasket. Route fill hose out
the rear left side of unit.
NOTES:
Do not use Teflon tape with compression fittings.
®†
■
Do not over-tighten. Damage to the coupling can result.
■

DRAIN HOSE CONNECTION

19.
Connect drain hose
Small clamp
Rubber drain hose
connector
Stop
Place towel under drain hose to catch any water in drain hose.
Place the small (green) drain hose clamp onto the small end
of the drain hose. Push the new drain hose into the rubber
drain hose connector up to the drain hose stop.
20.
Slide clamp onto connector
Small clamp
Rubber drain hose
connector
Stop
Using pliers, squeeze open the small drain hose clamp and
slide it onto the connector between stops.
†
TEFLON is a registered trademark of Chemours.
®
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
1 / (12.7 mm) turn
2
Drain hose
Drain hose stop
Stop
Drain hose
Drain hose stop
Stop
13