Led And Beeper Indications; Software Download - Generalscan GS P10 Quick Start Manual

LED AND BEEPER INDICATIONS

Operation
Power on
Decoding successful
Decoding failed
Configuration Barcode
decoding successful
Switch illumination mode

SOFTWARE DOWNLOAD

Please download the PC configuration software EasyScan for
other configurations of the scanner from our website:
www.generalscan.cloud
Q & A
Problem
Scanner not
working
Scanner not
decoding bar
code
Scanner
deoding
barcode,
but data not
transmitting
to host
LED Indicator
Aiming stays on
Decoding LED flashes
green once
Decoding LED flashes
red once
Decoding LED flashes
green once
Illumination mode LED
stays on
Possible Causes
No power to scanner
Scanner not programmed
for barcode type
Barcode not clear,
damaged
Distance between scanner
and bar code incorrect
Host interface not
configured properly
Interface cable is loose
Beeper Indicator
Three beeps
One beep
Low beeps
Two beeps
Two beeps
Possible Solution
Check system power
Ensure scanner is programmed
to read type of bar code being
scanned
Ensure barcode is not defaced
Move scanner closer to, or further
from barcode
Scan appropriate host parameter
barcodes
Ensure all cable connections