Power Supply - Advantech ICR-2834 Hardware Manual

2. Hardware Functionality

2.4 Power Supply

The pins of power supply are physically connected to the 6-pin terminal block panel socket located on
the left panel. The connection of power supply is shown in Figure
Pin
1
2
Required power supply voltage for the router is between +9 V and +48 V DC, see the connection scheme
on Figure 13. Protection against reversed polarity without signaling is built into the router. For correct
operation it is necessary that the power source is able to supply a peak current of 1 A.
Unit has to be supplied by a power supply specified as a Limited Power Source (LPS) or CEC/NEC
Class 2 source of supply.
All metal parts of the router in a metal box, including the box itself, are connected with the negative pole
of the power supply (common pole). If recommended for the installation environment, protect the router by
grounding it properly by the grounding screw, see Figure 14.
ICR-2834 Hardware Manual
Figure 13: Connection of Power Supply
Signal mark Description
PWR(+)
Positive pole of DC supply voltage (+9 to +48 V DC)
PWR(-)
Negative pole of DC supply voltage
Table 5: Power Supply Pinout
Figure 14: Position of the Grounding Screw
13 and described in Table 5.
2.4 Power Supply
18