Table of Contents
Advertisement
7 WALL CHARACTER
Sets characteristics for sound that is reflected from the walls.
Simulates the material of the walls.
Graph
Graphs the volume of the reflected sound and attenuation of its high frequency component.
If you move the cursor in the graph, a bending point (■) is displayed. You can edit the graph by dragging this point with the
mouse.
DELAY [ON] Button/[DELAY] Knob
Sets whether or not to include a delay time for the distance from the sound source to the listener.
This is normally ON, but when Room ER is being used for a surround mix in a composition, it will cause a deviation rhythm
with respect to other instruments, and should be turned OFF.
[REF] Display/[WALL REF] Knob
Adjusts the volume of reflected sound.
You can change this value by double clicking in the Room ER window, then typing a number from the keyboard, or by
dragging vertically with the mouse.
[LPF] Display/[REF LPF] Knob
Adjusts attenuation of the high frequency component of the reflected sound.
You can change this value by double clicking in the Room ER window, then typing a number from the keyboard, or by
dragging vertically with the mouse.
8 SURROUND MODE
Sets surround characteristics.
SURROUND MODE Display
When the surround mode is 6.1, "6.1" is displayed. "3-1" is displayed for 3-1 surround, and "5.1" is displayed for all others.
[DIV] Knob/[DIV F] Knob
Sets right and left for the front center signal, along with the percentage sent to the center channel.
When the surround mode is 6.1, [DIV.F] is displayed. For all others, [DIV] is displayed.
[DIV.F] is always displayed in the Generic Editor window and console.
DIV/DIV F Display
Sets the DIV/DIV F value.
You can change this value by double clicking, then typing a number from the keyboard, or by dragging vertically with the
mouse.
If the setting is zero, only L/R is used. If 50 is set, the ratio between L/R and the center will be 50:50. When 100 is set, the
signal will go to the center channel only.
[DIV R] Knob
Sets right and left for the rear center signal, along with the percentage sent to the center channel.
This is displayed in the Room ER window only when Surround Mode is 6.1. Otherwise it will be grayed out.
8
Advertisement
Table of Contents
