Table of Contents
Advertisement
REMOTE CONTROL UNIT (CU-V150 /sold separately)
This remote control unit (CU-V150) is available as a separately purchased option, and is not included with the SA-V350
or SA-V300.
INSERTING BATTERIES IN THE BIE)
CONTROL UNIT
1. Open the cover of the battery case on the rear side
of the remote control unit.
2. Take out the two supplied batteries (AAA/RO3), and
insert them into the battery compartment in accor-
dance with the indications in the compartment.
3. Close the cover.
[ PANEL FACILITIES
ene
STER VOLUME
KEY CONTROL
Q PIONEER
ACAUTION
Incorrect use of batteries may lead to leakage or
rupture. Always be sure to follow these guidelines:
A: Always insert batteries into the battery compartment
correctly matching the positive (+) and negative (-)
polarities, as indicated inside the compartment.
B: Never mix new and used batteries.
C: Batteries of the same size may have different voltages,
depending on their type. Do not mix different types
of batteries.
@ MAIN VOLUME ( —, + ) button
Controls the volume of the sound from the speakers.
@MIC MASTER VOLUME ( —, + ) button
Use to simultaneously adjust the sound volume of all
microphones (MIC 1-3).
@KEY CONTROL (4,¥) button
& : Changes to a higher key.
vy : Changes to a lower key.
The optional remote control unit (CU-V150) allows you
to control the amplifier from a remote Jocation. Point
the remote contro! unit at the amplifier's sensor. The re-
mote control unit can be used within a distance of 7 m
and at up to an angle of 30 degrees.
@ The remote control unit might not operate properly
when an obstacle exists between the sensor and the
remote contro} unit. Also, the remote control unit
might not work if it is pointed from an improper
angle.
@ Remote contro! operation might not work if the re-
mote control sensor is directly hit by strong fluores-
cent light. In such a case, place the fluorescent lamp
away from the amplifier.
@ If the remote control unit is used near a device emit-
ting infrared rays, or another remote control unit
using infrared rays is operated nearby, improper
operation might occur. Also, a device using infra-
red rays might operate improperly if the remote con-
trol unit is used near the device.
@ Replace the batteries if the available operation range
of the remote control unit becomes very small.
@ To prevent leakage, remove the batteries if you do
not use the remote control unit for a long period
{more than 1 month).
8
<BRA1107>
En
Advertisement
Table of Contents
