Table of Contents
Advertisement
OPERATION
ENJOY THE ECHO EFFECT
AUTO SOURCE SELECTOR
1. LD1
2. LD2
3. VCR/TAPE
4. CABLE
Input sensitivity of LD1 and LD2 can be switched only
when the AUTO SIGNAL DETECTION button is set to
AUDIO.
Automatic output switching of TV monitor
When function is set to LD1, LD2, or VCR/TAPE, the video
image corresponding to the currently selected function
is output through the VISUAL OUTPUT (MON 1-3) jacks.
When function is set to CABLE, the VCR/TAPE image is
output through the VISUAL OUTPUT (MON 1-3) jacks.
Fade-in function for cable
When the SA-V350/SA-V300 is switched from LD1, LD2
or VCR/TAPE mode to CABLE mode, the fade-in circuit
is activated and the volume level gradually increases to
the level that has been set by the MASTER VOLUME con-
trol after approx. 2 to 8 seconds.
[ ECHO
|
® Adjustment of the Microphone Echo Volume
@ Echo Adjustment
Echo can be adjusted by the following:
REPEAT:
DELAY:
Changes the echo intervals to enhance the echo effect.
Adjust the intervals according to the tempo of the tune.
10
<BRA1107>
En
@ To Maximize the Echo Effect for Karaoke (Sing-
Along) :
Set the sound volume of the music slightly lower than
the vocal.
This will improve the mixing balance and maximize the
echo effect.
Advertisement
Table of Contents
