Pioneer CDJ-500G Service Manual page 35

Screw (1)
Door @— Washer
Eject button
| =z
a
4. Remove the five screws @ on the side surface of the
control panel.
5. Close the door and then disengage the contro! panel from
the chassis.
6. Insert the contro] panel under the chassis and secure it.
Screw @) Door
Wash Washer
asher \ a Screw @)
Screw 2)
Washer Chassis
7, When disconnecting the flexible cable from the connec-
tor for maintenance, etc., be sure to unplug the power
cord and then remove the flexible cable without twisting
it by holding it with both hands and by both ends.
(Even when the power is off, a residual electrical charge
remains in the capacitors and the like. If the terminal of
the flexible cable and the terminal of the connector acci-
dentally touch damage to components may occur.)
Flex cable
Connector
@ Error display
CDJ-500G, CDJ-500
(Note 1) Important
Opening the door and disengaging the control
panel in an emergency
This model is equipped with a mechanism that enables you to
open the door manually if it does not open even when the
Eject button is pressed.
1. Unplug the power cord.
2. Prepare a key by using a zem clip (a metal rod with a
diameter of approximately 1mm and a length of 50mm).
Insert the key into the hole at a right
angle then push it down to the left.
va
Door
Hook
Control
pane!
remove the screw (1).
Door Screw driver
Screw ()
=
Shutter Disc table
(Note) Do not open the door any wider than necessary
because, depending upon the position of the servo
mechanism, the disc table may come into contact
with the shutter, which may damage these compo-
nents.
in Be sure to close the door after removing the screw.
6. You can separate the control panel from the chassis by
removing all the screws (2) on the control panel.
7. The door opens completely when the hook drive lever on
the control panel is moved from the inside of the control
panel in the same direction as in 3.
The error No. is displayed on the FL indicator when a player operation error occurs during normal operation.
TOC READ ERROR
PLAYER ERROR MECHANICAL TIME OUT
Description TOC data on disc could not be read after | The disc cannot be played normally. Operation is not completed after maxi-
20 seconds. GFS No Good judgment: 2 sec x 3 times | mum set operating time is exceeded.
continuous. Clamp: 4 sec
Focus No Good judgment: 0.1 sec x 3 | Open: 4 sec
times continuous.
Probable Cause * Disc is dirty.
¢ Problem with the pick-up.
¢ Disc is dirty.
¢ Disc is scratched.
¢ Object is on door.
¢ Trouble at door open/close mecha-
nism.
1-35