Section 6: Maintenance; Maintenance Schedule; Decorative Trimming - Cub Cadet Series CC3000 Operator's Manual

Operation (continued)
Fig. 5-6
Section 6
MAINTENANCE
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about these
procedures take your unit to an authorized service
dealer.

MAINTENANCE SCHEDULE

These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-
up.
WHEN
Before Starting Engine
Every 10 Hours
Every 25 Hours
12
MAINTENANCE NEEDED
Fill fuel tank with correct oil and fuel mixture.
Clean and re-oil air filter.
Check spark arrestor and clean
Check spark plug condition and gap

DECORATIVE TRIMMING

Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment is
at a 30° angle to the ground (Fig. 5-6).
To prevent serious injury, never do maintenance
or repairs with unit running. Always do
maintenance and repairs on a cool unit.
Disconnect spark plug wire to ensure the unit will
not start.
GO TO:
Page 9
Page 15
Page 15
Page 17