National Instruments SCXI-1129 User Manual page 15

Chapter 1 Installing and Configuring the SCXI-1129
10
1 AB0+
2 AB0–
3 NI 4060 for PCI
4 AB2+
Note When installing the SCXI-1129 module in an SCXI chassis, the rightmost slot
(when the chassis is viewed from the front) must be filled first, then fill the slot to the left
with the next SCXI-1129. You can load other SCXI modules from left to right.
SCXI-1129 User Manual
To install your SCXI-1129 module into the SCXI chassis, refer to
Figure 1-1 while completing the following steps:
9
8
5 AB2–
6 HV8-BAN4
7 SH9MD-9MD
Figure 1-1. Installing the SCXI-1129 into an SCXI Chassis
1. Power off the computer that contains the DAQ/DMM device or
disconnect it from your SCXI chassis.
2. Power off the SCXI chassis. Do not insert the SCXI-1129 module into
a chassis that is powered on.
3. Insert the SCXI-1129 module into the rightmost slot. Gently guide the
module into the module guides and push it to the back of the slot until
the connectors make good contact. The module must be firmly
engaged; however, do not force the module into place.
7
8 2-Slot HVAB-Backplane Adapter
9 SCXI Chassis
10 SCXI-1129 Module
1-6
1
4
5
6
2
3
ni.com