Time Adjustment; Adjusting The Current Time Setting - Casio 3545 Operation Manual

Note
Auto Light is disabled when any one of
●
the conditions below exists.
Alarm, timer alert, or other beeper
ー
sounding
Configuring the Auto Light Setting
●
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (B) for at least three seconds
to toggle Auto Light between enabled and
disabled.
[LT] is displayed while Auto Light is
●
enabled.
Note
Auto Light is disabled while [CHG] is
●
shown on the display.
Watch Operation Guide 3545
Specifying the Illumination Duration
●
You can select either 1.5 seconds or three
seconds as the illumination duration.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the city code
starts to flash.
3.
Press (C) 10 times.
[LT] appears on the display with [1] or [3]
flashing.
4.
Press (D) to select an illumination
duration.
[LT1]: 1.5-second light
[LT3]: 3-second light
5.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
City code

Time Adjustment

Use the procedures in this section to adjust the
date and time settings.
Adjusting the Current Time
Setting
Use the procedures below to adjust the
current date and time settings, and to select a
Home City.
Setting a Home City
●
Use the procedure in this section to select a
city to use as your Home City. If you are in an
area that observes summer time, you can also
configure a summer time setting.
1.
Enter the Timekeeping Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least two seconds.
Release the button when the city code
starts to flash.
City code
3.
Use (B) and (D) to change the Home City
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
For details refer to the information
●
below.
City Table
l
8