Operation - Frank iStream iS18 Operating Instructions Manual

6.

Operation

Operating resources:
Cleaning / care products (OPTIONAL):
Only cleaning/care agents approved by the manufacturer may be used
for the cleaning/care agents approved by the manufacturer in order to
ensure material compatibility.
Preparation for commissioning, factory settings:
Compare the data on the type plate with the technical data in these operating
instructions.
Factory settings:
The machine is factory set and checked to the technical data mentioned in section 3.
Handle bar:
Mount the handlebar on the machine with the enclosed screws.
Electrical connection:
The machine is supplied with a connection cable with mains plug.
Insert the plug into a properly installed socket outlet with a
protective earth connection. The electrical connection with socket
must be in accordance with the latest edition of the applicable
IEC standard and installed by a qualified electrician.
The socket must be protected with a 32 A slow-blow fuse.
It is recommended to equip the electrical connection of the machine with a residual
current circuit breaker type B (all-current sensitive), which interrupts the power
connection if the leakage current to earth exceeds 30 mA.
If an extension cable is used, it must be of quality
HO7RN-F quality and must have a protective earth conductor
connected to the plug connections in accordance with the regulations.
The conductors of the extension cable must have a minimum cross-
section of 4mm² for 400V and 480V of 4mm² at 3x 230V 6mm².
For plug connections must be splash-proof and must not lie on a wet
floor. Not lie on a wet floor.
Attention:
Extension cables that are too long cause a voltage drop and thus operating faults and
start-up difficulties.
14