Table of Contents
Advertisement
For use with Chamberlain 315 MHz or 390 MHz garage door
openers manufactured after January 1, 1993. The garage door
opener activates when the 4-digit Personal Identification Number
(PIN) and ENTER button are pressed on the Keyless Entry.
Install the battery and program the Keyless Entry prior to
installation. Make sure the garage door opener has a working
light bulb because it is a programming indicator.
PREPARE
3
Press and release the Enter button the number of times that
corresponds with the garage door opener type:
# of Presses Garage Door Opener Type
1
Security+ 2.0
®
(Yellow Learn Button)
2
315 MHz Security+
3
390 MHz Security+
4
390 MHz Billion Code (Green Learn Button)
To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener.
CHANGE AN EXISTING PIN*
1
2
Press the programmed PIN
that you want to change.
? ? ? ?
*
For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
• Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and away from ALL
moving parts of door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
Locate the Learn button on the garage door
opener.
NOTE: Your garage door opener may
look different.
Learn
LED
OR
Learn
LED
Green or
Red/Orange
Purple
4
To exit programming
mode, press the
0 button.
®
(Purple Learn Button)
®
(Red/Orange Learn Button)
Press and hold the
# button until...
...the light bulb blinks twice.
WIRELESS KEYLESS ENTRY • MODELS 940EV AND 940EVC
PROGRAM INITIAL PIN
1
Learn
LED
OR
Yellow
5
Press and release the Learn
button on the garage door
opener.
The Learn LED will light.
Within 30 seconds...
3
Enter the new 4-digit PIN of your choice,
then press the ENTER button.
+
? ? ? ?
new PIN
2
Press and hold
the
and #
*
buttons until
the lights on
the keypad
stop blinking.
6
Enter the 4-digit personal identification
number (PIN) programmed in step 2
then press and release the Enter button
until the garage door opener lights flash
or two clicks are heard.
Learn
Button
The light bulb will blink once.
www.chamberlain.com/CatalogResourcesV3/en-us/shared/files/tucmanuals/114A3926SP.pdf
Enter a 4-digit personal identification
number (PIN) of your choice:
? ? ? ?
Then press the # button.
7
To test, press
the PIN, then
press the ENTER
button.
The garage door
opener will activate.
4
To test, press the new PIN,
then the ENTER button.
The garage door opener
will activate.
Para Manual en Español ir a:
Advertisement
Table of Contents
