Vhs Address Search System (Vass) - Panasonic AG-7330 Operating Instructions Manual

VHS ADDRESS SEARCH SYSTEM (VASS)
Locate the beginning of a desired programme by selecting the number of the address signal recorded on the tape at that position.
To be able to use the VHS Address Search function, address signals must be recorded on the tape.
eWhen recording address signals, space them so that the interval between two signals is more than 2 minutes in normal playback
time.
Recording Address Signals
Address signals (numbered search signals) can be recorded
during recording or on already recorded tapes.
A desired 4-digit number (0000-9999) can be assigned to each
address signal.
¢For optimum convenience when later locating desired pro-
grammes, write down the numbers assigned to the recorded
address signals on the cassette label.
ISS _VASS
MODE SEARCH WRITE SCREEN > v +
COUNTER ERASE DISPLAY SHIFT = DOWN OATA
Use the buttons above and perform the following operations
by ON-SCREEN mode and the tape counter.
To Record Address Signals during
Recording
Example: When recording the address signal "1964".
1. Press the MODE Button and light the VASS mode indicator
in the tape counter.
AUDIO LIMITER
DOLBY NR
TIME CODE
SERVO LOCK
<<
<fasg
>» 4
2. Press the SCREEN DISPLAY Button.
VASS
REPEAT OFF
BGN 0000
END 0000
3. Press the SHIFT Button and display the VASS WRITE
menu.
4. Press the DOWN Button so that the digit will flash.
5. Press the DATA Button to display "1". Press the SHIFT
Button.
VASS
WRITE
hom
v
6. Press the DATA Button repeatedly to display "9". Press the
SHIFT Button.
VASS
'RITE
+9
7. Continuously set "6" and "4" with the DATA and SHIFT
Buttons. When completed, press the SHIFT Button.
VASS
WRITE
1964
8. Press the WRITE/ERASE Button at a point that you may
want to locate again later using the VHS Address Search
function. Recording starts and the VASS mode indicator in
the tape counter flashes.
AUDIO LIMITER
» <4
If the operation step 8 is performed while the VTR is in the
recording pause mode, the pause mode will be canceled, the
recording will restart and the address signal will be recorded.
To Record Address Signals ona
Recorded Tape
Play back the tape to locate a point that you may want to locate
again later using the VHS Address Search function, and put
the VTR in the still playback mode.
1. Put the VTR in the pause still mode where you desire to
locate again later.
Tobe.