Table of Contents
Advertisement
When the food is ready, use
‒
pliance off.
Changing the end time
To achieve good cooking results, only change the set
time before the operation starts and before the cooking
time starts counting down.
Press "Stop"
1.
Press "End time"
2.
Change the time using the adjustment line or enter
3.
it directly via the number field
Press "Start"
4.
Cancelling the end time
You can delete the set time at any time.
Press "Stop"
1.
Press "End time"
2.
Use
to reset the time.
3.
Note: For operating modes that always require a
cooking time, the appliance resets the time at which
the cooking time ends to the next possible time.
4.
Press "Start"
10.3 Setting the timer
The timer runs independently during the operation. You
can set the timer when the appliance is switched on or
off, up to 24 hours. The timer has its own signal so that
you can tell whether it is the timer or a cooking time
that has elapsed.
Steaming
11 Steaming
Food can be cooked particularly gently using steam.
You can use the special types of steam heating, or use
steam assistance with certain types of heating.
WARNING ‒ Risk of scalding!
Hot steam may escape when you open the appliance
door. Steam may not be visible, depending on the tem-
perature.
Open the appliance door carefully.
▶
Keep children at a safe distance.
▶
11.1 Before using the steam function
Before using the steam function each time, make sure
that your appliance is supplied with sufficient water.
Filling the water tank
WARNING ‒ Risk of fire!
Due to the hot surfaces, vapours from flammable li-
quids may catch fire in the cooking compartment (ex-
plosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
Do not pour flammable liquids (e.g. alcoholic drinks)
▶
into the water tank.
Only fill the water tank with water or with the descal-
▶
ing solution we have recommended.
to switch the ap-
.
Press the
button.
1.
To set the timer, press the relevant time value on
2.
the display, e.g. hour display "h" or minute display
"min".
a The selected value is marked in blue.
Set the timer
using the number field.
3.
If required, use
to reset the setting value.
Press "Start" to start the timer.
4.
a The timer counts down.
a The timer remains visible on the display if the appli-
ance is switched off.
a When the appliance is switched on, the display
shows the settings for the current operation. The
timer is displayed in the status bar.
a Once the timer has elapsed, a signal sounds. A
message appears on the display confirming that the
timer has finished.
Changing the timer
You can change the timer at any time.
Press the
button.
1.
Press "Pause".
2.
Change the timer.
3.
Press "Start".
4.
Cancelling the timer
Press the
button.
1.
Reset the timer using
2.
Close with
3.
WARNING ‒ Risk of burns!
The water tank may heat up while the appliance is in
operation.
Wait until the water tank has cooled down from the
▶
previous operation.
Remove the water tank from the tank recess.
▶
Requirement: The water hardness is set correctly.
Press
.
1.
a The control panel pops out automatically.
Pull the control panel towards you with both hands
2.
and then push it upwards until it clicks into place
Remove the water tank from the tank recess
3.
Press down on the water tank lid along the seal to
4.
prevent water from leaking out of the water tank.
Remove the cover
5.
Steaming en
.Reset the timer using .
on the water tank.
.
.
19
Advertisement
Table of Contents
