M.2 Solid-State Drive - Lenovo ThinkPad E14 Gen 6 User Manual

For access, do the following:
1. Disable the built-in battery. See "Before you replace any CRU" on page 27.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 28.
Step 1. Remove the memory module as shown below.
Step 2. Install the memory module as shown below.

M.2 solid-state drive

Follow the instructions to replace the M.2 solid-state drive.
Before you start, read
Generic Safety and Compliance Notices
Attention: The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for repair. The M.2 solid-state drive is not designed for frequent
changes or replacement.
30
ThinkPad E14 Gen 6 / ThinkPad E16 Gen 2 Linux User Guide
and print the following instructions.