2242 M.2 Solid-State Drive And Bracket - Lenovo 21E80024IX User Manual

Installation procedure (for wireless WAN card with two antennas)
Note: During installation, ensure that you connect the cables with different colors to the corresponding
connectors on the card according to the illustrations above: the orange cable to the connector labeled
ORANGE, the blue cable to the connector labeled BLUE.

2242 M.2 solid-state drive and bracket

Prerequisite
Before you start, read
Generic Safety and Compliance Notices
Attention:
• If you replace a M.2 solid-state drive, you might need to install a new operating system. For details on how
to install a new operating system, see "Install a Windows operating system and drivers" on page 38.
The M.2 solid-state drive is sensitive. Inappropriate handling might cause damage and permanent loss of
data.
When handling the M.2 solid-state drive, observe the following guidelines:
• Replace the M.2 solid-state drive only for upgrade or repair. The M.2 solid-state drive is not designed for
frequent changes or replacement.
• Before replacing the M.2 solid-state drive, make a backup copy of all the data that you want to keep.
• Do not apply pressure to the M.2 solid-state drive.
• Do not touch the contact edge or circuit board of the M.2 solid-state drive. Otherwise, the M.2 solid-state
drive might get damaged.
• Do not make the M.2 solid-state drive subject to physical shocks or vibration. Put the M.2 solid-state drive
on a soft material, such as cloth, to absorb physical shocks.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 41.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
and print the following instructions.
Chapter 6
. 45
CRU replacement