Advertisement
mn--a2m
46
Installation (continues)
@ Using the Rubber Cushion (Option)
(If there is an existing Rear Support Bracket on the fire wall of car.)
Cover Mounting Bolt @ on the rear of the unit with Rubber Cushion, and mount it into the existing Rear
Support Bracket.
Rear Support Bracket
(Existing on the car)
Rubber Cushion
(Option)
3. Insert Trim Plate ©.
© Trim Plate
4. After installation reconnect the nega-
tive (—) battery terminal.
To Remove the Unit
a) Remove the removable face plate. (See page 41.)
b) Remove Trim Plate © with a screwdriver as shown in the figure.
© Trim Plate
Screwdriver
c) Pull out the unit while pushing the lock lever using screwdriver. (Fig. 7, Fig. 8)
d) Remove the unit pulling with both hands. (Fig. 9)
Fig. 8
Screwdriver
CQ-FX820/FX720N
Advertisement
