Table of Contents
Advertisement
INSTALLING MOTOR PULLEY
1. Find the pulley in loose parts bag.
2. Slide pulley onto motor shaft. Line up the flat
sur~
face in the motor shaft with the set screw in pulley.
3. Make sure the pulley does not rest on the lower guard.
4. Tighten the set screw using a 5 mm Hex IIL" wrench.
INSTALLING AND -rENSIONING BELT
WARNING: TO AVOID INJURY DUE TO ACCIDEN·
TAL STARTING ALWAYS TURN DRILL PRESS
OFF AND REMOVE SWITCH KEY BEFORE MAK
ING BELT ADJUSTMENTS.
1. Place a straight edge such as a piece of wood,
metal, or framing square across the top of pulleys.
2. Move the motor upward until the pulleys are in line.
Tighten the motor mount nuts using an adjustable
wrench.
NOTE: To avoid rattles or other noise, motor frame
must not touch lower belt guard.
3. Release Belt Tension Lock handles located on
each side of Drill Press head by turning them
counter clockwise.
LOWER BELT
GUARD
MOTOR
12
Advertisement
Table of Contents
