INSTALLING FEED HANDLES
1. Locate three (3) feed handles among loose parts.
2. Screw the feed handles into the threaded holes
in the hub and tighten.
INSTALLING THE CHUCK
1. Clean out the TAPERED HOLE in the chuck.
Clean the tapered surface on the arbor with a
clean cloth. Make sure there are no foreign par
ticles s{icking to the surfaces. The slightest
piece of dirt on any of these surfaces will pre
vent the chuck from seating properly. This will
ca~se
the drill to "wobble."
CLEAN THIS
SURFACE
14 .