Table of Contents
Advertisement
assembly
WARNING: FOR YOUR OWN SAFETY, NEVER
CONNECT PLUG TO POWER SOURCE OUTLET
UNTIL ALL ASSEMBLY STEPS ARE COMPLETED.
COMBINATION SQUARE MUST BE TRUE.
Ch.eck its accuracy as illustrated below.
STRAIGHT "EDGE OF
DRAW LIGHT
BOARD 3/4" THICK
LI NEON BOARD
THIS EDGE MUST BE
ALONG THIS EDGE
- - - - - - TOOLS NEEDED - - - - -
PERFECTLY STRAIGHT
.(J;J
V . . . , . . , :
: r-r:
r " " " ' :
:
"P'T:
:
, . . . . . : :
'T""":
: "'T""l:,..,....;...,..:
: ......,: :-.-,,,
~
COMBINATION SQUARE
SHOULD BE NO GAP OR OVERLAP WHEN SQUARE IS FLIPPED OVER
MEDIUM
8-INCH ADJUSTABLE
IN DOTTED POSITION
SCREWDRIVER
~R~~~H
oJ
ASSEMBLY OF BASE/COLUMN
1. Position base on floor. Remove protective cover
ing and discard.
2. Remove protective sleeve from column tube and
discard. Place column assembly on base, and
align holes in column support with holes in base.
3. Locate four (4) 10 mm Dia. x 40 mm long bolts in
loose parts bag.
4. Install a bolt in each hole through column support
and base and tighten with adjustable wrench.
5. Locate table crank and support lock in loose
parts box.
6. Install support lock from left side into table sup
port and tighten by hand.
7. Install table crank assembly and tighten set
screw with a 3 mm Hex ilL" wrench. Do not over
tighten. Set screw should be tightened against
the flat section of the shaft.
NOTE: To minimize crank backlash, tighten sup
port lock, rotate elevation worm shaft clockwise,
then assemble crank tight against table support
and tighten set screw.
8. Check column collar for proper adjustment.
Collar should not be angled on the column and it
should be positioned so rack will slide freely in
collar when table is rotated 360
0
around column
. tube. If re-adjusted, only tighten set screw
enough to keep collar in place.
NOTE: 'To avoid column or collar damage, do not
overtighten set screw.
10
mm
DIA. X 40
mm
LONG BOLT
RACK
COLUMN
ELEVATION
WORM
SHAFT
ROTATE
CLOCKWISE
ROTATIONAL
/POSITION OF
SET SCREW IS
NOT IMPORTANT
10
Advertisement
Table of Contents
