Advertisement
3.2.
FITTING THE CONVENTIONAL DRILL CHUCK (See fig.2-D)
F
WARNING! Unplug from the mains power supply before assembling chuck.
p
F
WARNING! ensure you remove the chuck key before starting the drill.
I
CAUTION! To avoid overloading the motor when using the chuck in the hammer mode, DO NOT apply a too heavy pressure.
DO NOT USE CHISELS OR ‘HAMMER’ MODE ONLY when using the conventional chuck, as chuck will be damaged.
s
3.3.
SELECTION OF OPERATIONAL MODES
Control of hammer action.
Rotation on/off selection.
These two controls are used
in combination to select the
three operational modes of
the drill as shown in fig.3.
Drill with hammer action.
Hammer action only.
(For use with a chisel)
Drill without hammer action.
4. INSTRUCTIONS FOR APPLICATION
F
WARNING! ensure you wear approved safety goggles and any other safety items required for the job. If using conventional chuck,
remove the chuck key before using the drill. Also ensure that all other safety requirements are followed.
p
F
WARNING! In all cases below, be prepared for drill binding or break through. When these situations occur the drill has a tendency
to grab and kick in the opposite direction and could cause loss of control. If you are not prepared this can result in possible damage
p
and/or personal injury. Where possible, place a wooden block under metal work piece at the point where the drill will break through.
4.1.
DRILLING MASONRY, BRICK, STONE, ROCK OR CONCRETE.
The hammer action can be used if required on brick, stone, rock or concrete.
4.2.
CHISEL .... USE on MASONRY, BRICK, STONE, ROCK OR CONCRETE.
F
WARNING! DO NOT USE DRILL MODE, use hammer action only. DO NOT USE WITH CONVENTIONAL CHUCK.
p
4.3.
DRILLING WOOD AND PLASTIC.
DO NOT use the hammer action when drilling wood or plastic materials.
fig 3
Advertisement
