General; Safety Instructions; Environment; Mounting And Dimension - Val Controls IHP24-A Hardware Manual

Hide thumbs Also See for IHP24-A:

Table of Contents

1 General

This manual covers the following products:

IHP24-A-000001-C – No communication bus

IHP24-A-100001-C – HART communication on control loop

IHP24-A-300001-C – Foundation Fieldbus

For a safe installation of a Val Controls device, the following must be observed. The module must

be installed by qualified personnel who are familiar with the national and international laws,

directives and standards that apply to this product as well as all instructions in this manual.

The information in this manual is subject to changes without notice.

Operating temperature: -30 to 80 ˚C

Storage temperature: -30 to 80 ˚C

Extended operating temperature

Extended storage temperature

Please contact Val Controls

Relative Humidity: < 95% (No condensation)

The printed circuit boards are coated for tropical climate and harsh environments to resist airborne

contamination according to G3, ISA-71.04-2013.

Ingress protection: IP20

Mounting: 35mm DIN rail according to EN50022.

Screw torque: 0.4Nm (3.6Lb. in)

Wire diameter: AWG14-22 (0.5mm² til 2.5mm²)

Val Controls A/S • Sallingsundvej 5 • DK-6715 Esbjerg N • Tel. +45 7547 0600

DHW-UM-016

Revision: 1

: -40 to 85˚C

: -55 to 100˚C

vc@valcontrols.com • www.valcontrols.com

3/14

Table of Contents