Table of Contents
Advertisement
TO REMOTELY CONTROL THE VIDEODISC PLAYER
The control unit can be detached from the player by sliding
it toward you while pressing the RELEASE button. It can be
used either as
a
wireless or a wired remote control unit.
RELEASE---
To attach, slide the control unit until it is plugged in firmly.
Notes on the control unit
• Keep the control unit away from hot or humid places.
• Avoid dropping any foreign objects into the control unit.
• To avoid a malfunction, do not press two or more function
keys simultaneously.
WIRED REMOTE CONTROL
Once the POWER button on the player is depressed and the
player and the control unit are connected with the supplied
remote cable, you can remotely control the player with the
control unit detached from the player. Connect the remote
cable to the remote jack on the control unit and the
REMOTE jack on the player.
=
•
to REMOTE
I
to remote
♦
jack
~
□□□ =
□□ ace
□ a □
CIC
□ OQ
CID
□ a □
cc
WIRELESS REMOTE CONTROL
Once the POWER button on the player is pressed, you can
remotely control the player with the detached control unit
up to 10 meters (3 feet) away from the player and within the
range illustrated below.
The red lamp of the COMMAND SENSOR blinks to indicate
that a function key has been pressed.
=
COMMAND SENSOR
Battery installation
•
10 meters
~
□□□
00
□□□
OD
□□□
CJlJ
CICJCI
l:IlJ
□□□
ao
The control unit operates on batteries when it is used
without the remote cable. To install the batteries, press
down and slide open the battery compartment lid and install
the three batteries size AA (\EC designation R6) with the cor-
rect polarity. Then close the lid.
• In normal operation, battery life is over six months. When
the batteries are exhausted, the remote control unit will not
operate the player properly. When this happens, replace all
the batteries.
• If the control unit is not to be used for a long period of
time, remove the batteries to avoid damage from possible
battery leakage.
13
Advertisement
Table of Contents
