Table of Contents
Advertisement
TV ADJUSTMENT
Adjust your TV receiver to accept the signal from your player
in this way;
On the player
1. Set the RF CHANNEL selector located at the rear of the
player to CH-3 or CH-4, whichever channel is not active in
your area.
2. Set the antenna selector to VDP.
3. Press the POWER button to turn on the player.
4. Press the OPEN button and insert a disc. (See page 12.)
RF CHANNEL
=
Antenna selector
OPEN
POWER
TO SEE A PICTURE WITH A VIDEO MONITOR
On the TV
5. Turn on the TV.
6. Set the channel on the TV receiver to the VHF channel 3
or 4, depending on the setting of the RF CHANNEL selec-
tor. The program of the disc will be displayed on the TV
screen.
If a picture does not appear on the TV screen or if the
display is not clear, fine tune the channel on the TV.
If your TV receiver has an electronic tuner and does not
have a button for VHF channel 3 or 4, adjust a channel
select button so that the program of the disc is clearly
displayed on the TV screen and the sound is clearly
heard.
• For details about TV channel adjustment, see the instruc-
tion manual furnished with the TV receiver.
Now the TV receiver has been correctly tuned to receive the
signal from the player.
Once you connect a monitor, you can watch the playback picture on the monitor screen.
When connecting a monitor
not equipped with an 8-pin
connector
(Input select switch to LINE)
VIDEO OUT
When connecting a monitor
equipped with an 8-pin
connector
(Input select switch to VTR)
LINE OUT
• When connecting, align the
plug with the connector and
~~
When disconnecting, press
the buttons on the plug and
pull.
••Align the slot with the
projection, insert and tighten
the knurled locking ring
clockwise.
~
11
Advertisement
Table of Contents
