Related Manuals for Tallymatics TW5354
Summary of Contents for Tallymatics TW5354
- Page 1 TW5354 Installation Manual TW5354 Installation Manual Visit us on the web: www.tallymatics.com Document # 61-5354-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Equipment Installation and Operation ................. 6 Information regarding installation ................. 6 Installation Considerations ....................6 RJ45 Cable Connector ......................7 Device Communication ....................... 7 NMEA Messages ........................8 TW5354 Configured Settings .................... 8 Flash Configuration ......................8 TW5354 Mechanical........................9... -
Page 4: Introduction
The TW5354 outputs standard NMEA 0183 output with navigation updates rates up to 5 Hz. The TW5354 supports RS422/485 as the serial interface and RS485 for the 1PPS time pulse. The input operating voltage supports a range of 5V to 36V. -
Page 5: Regulatory Notice
TW5354 Installation Manual Figure 2 TW5354 Antenna (Conical white shown) 2 Regulatory Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that the device does not cause harmful interference. This device may only be used if operated or installed in a transportation vehicle including motor vehicles and aircraft, all other modes of use are prohibited. -
Page 6: Equipment Installation And Operation
Recommended minimum 10cm ground plane with the antenna located at the center. The TW5354 has a 5-meter cable terminated with an RJ45 connector. Adaptor cables are available to interface to a PC and a variety of mobile radio devices. Please contact Tallymatics for details. -
Page 7: Rj45 Cable Connector
Figure 2 RJ45 - I/O Connector (looking onto the connector contacts) Device Communication The TW5354 smart antenna has been factory configured for out of the box operation. When the device is powered, NMEA messaging will be active immediately on the RS-422/485 TX signal pins. -
Page 8: Nmea Messages
GNGSA GPGSV GLGSV GAGSV GNGLL TW5354 Configured Settings The TW5354 has been configured with the following specific settings set: NMEA Version -> 4.1 (Required to support Galileo Constellation) Position Output Rate: 1Hz GNSS Configuration o GPS o GALILEO o GLONASS o w/ SBAS Navigation Dynamic Model ->... -
Page 9: Tw5354 Mechanical
TW5354 Installation Manual 4 TW5354 Mechanical Figure 3 Mechanical dimensions of the TW5354...