Related Manuals for Tallymatics TW5365
Summary of Contents for Tallymatics TW5365
- Page 1 TW5365 Installation Manual TW5365 Installation Manual Visit us on the web: www.tallymatics.com Document # 61-5365-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Information regarding installation ................. 5 Installation Considerations ....................6 Operational Considerations....................6 RJ45 Cable Connector ......................7 Device Communication ....................... 8 NMEA Messages ........................8 TW5365 Configured Settings .................... 8 Inertial Calibration Status ....................9 Flash Configuration ......................9 TW5365 Mechanical........................10... -
Page 4: Introduction
UDR positioning starts as soon as the ignition signal is applied and before the first GNSS fix is available. The TW5365 may be installed in any position in a vehicle without electrical connection to the vehicle speed sensor. The on-board accelerometer and gyroscope sensors result in a self-contained UDR which is self calibrating and provides reliable and consistent navigation. -
Page 5: Regulatory Notice
3 Equipment Installation and Operation Information regarding installation Tallymatics provides wiring instructions to electrically connect the TW5365 device to the vehicle battery in a manner consistent with industry best practices. Improper installation of aftermarket electronics within a vehicle can negatively impact the safety and security of the Driver (and Passengers) and could result in serious injury or death in the event of a collision. -
Page 6: Installation Considerations
UDR performance. The TW5365 has a 5-meter cable terminated with an RJ45 connector. Adaptor cables are available to interface to a PC and a variety of mobile radio devices. Please contact Tallymatics for details. -
Page 7: Rj45 Cable Connector
TW5365 Installation Manual RJ45 Cable Connector The smart antenna cable is terminated with an 8 position RJ45 signal connector which provides the following signals: Description Notes Color White/Green IGN/ENA ON(>5V) / OFF(<4V) Green TIMEPULSE RS-232 White/Orange RS-422 Blue RS-422 White/Blue... -
Page 8: Device Communication
TW5365 Installation Manual Device Communication The TW5365 smart antenna has been factory configured for out of the box operation. When the device is powered and enabled, NMEA messaging will be active immediately on the RS-232 TX signal pin. A device with factory default will be configured as: 9600,8,N,1 (A custom configuration may have another BAUD rates applied.) -
Page 9: Inertial Calibration Status
3-4 minutes of operating the vehicle in typical driving conditions providing the minimum quantity of each event type has been acquired. Note: The current state of the TW5365 sensor calibration may be polled using the ESF/STATUS message via the u-center development tool or directly from an embedded vehicle computing system. -
Page 10: Tw5365 Mechanical
TW5365 Installation Manual 4 TW5365 Mechanical Figure 3 Mechanical dimensions of the TW5365...