Related Manuals for Tallymatics TW5384
Summary of Contents for Tallymatics TW5384
- Page 1 TW5384 Manual TW5384 Multi-Band Precision Receiver/Antenna Manual Visit us on the web: www.tallymatics.com Document # 61-0084-0...
- Page 2 Tallymatics Inc. retains an exclusive right to reproduction, manufacture and sale. This document is submitted in confidence, for the use of the recipient alone, or in conjunction with Tallymatics Inc. and its licensees, and for no other purpose whatsoever unless permission for further disclosure is expressly granted in writing.
-
Page 3: Table Of Contents
Introduction ............................ 4 Equipment Installation and Operation ................. 5 Installation Considerations ....................5 Hardware Interface ........................5 Device Communication ....................... 6 TW5384 Configured Settings .................... 6 Simplified Configuration Tool ..................7 TruPrecision™ ......................... 7 Evaluation Tools ........................7 Developer References ......................7... -
Page 4: Introduction
Accutenna™, which greatly improves the rejection of multi-path signal interference. The TW5384 incudes augmentation capability to receive RTK or RTK-PPP augmentation via networked serial stream. With IP augmentation active, The TW5384 offers sub 6 cm accuracy through real-time PPP-RTK augmentation via the u-blox PointPerfect®... -
Page 5: Equipment Installation And Operation
10cm. The antenna may be installed in any reasonable orientation which allows optimal GNSS performance. 3 Hardware Interface The standard TW5384 is provided with a 5 m cable terminated in a RJ45 connector. Figure 2 Table 1... -
Page 6: Device Communication
TW5384 Manual 4 Device Communication The TW5384 smart antenna has been factory configured for out of the box operation. When the device is powered, NMEA messaging will be active immediately on the RS-485/422 TX signal pins. The serial interface has been factory configured as: 115200,8,N,1... -
Page 7: Simplified Configuration Tool
TW5384 antenna receiver to the u-blox Thingstream service and subscribe to the PointPerfect® SPARTN augmentation stream to experience a true “Out of Box” precision performance from the TW5384. The TW5384 TruPrecision Windows service application and quick start guide may be downloaded at the following link: https://tallysman.com/downloads/TruPrecision.zip... -
Page 8: Tw5384 Mechanical
The TW5384 Antenna assembly contains the following parts: TW5384 receiver Antenna with 5 Meter cable and RJ45 termination Two 0.75” (19mm) panel nuts. One metal washer A rubber gasket installed on the lower side of the TW5384 Figure 2 TW5384 Install Mechanical...